Connecting the Power Cord
Turning On the Power and Projecting Images
Turning On the Power and Projecting Images
Procedure
1 | Turn on the power for all equipment | |
connected to the projector. | ||
| For a video source, press the [Play] button at the | |
| video source to start playback if necessary. | |
| Check that the | indicator on the projector has |
| stopped flashing and lights orange. | |
Press the [STANDBY/ON] button on
2 | Lights green | either the remote control or the | |||
| |||||
|
| projector's control panel to turn on the | |||
|
| power. |
|
| |
|
| The | indicator flashes green, and after a | ||
|
| short period projection starts. | |||
|
| Check that the | indicator has stopped | ||
Projector | Remote control | flashing and lights green. (This takes | |||
approximately 15 seconds.) | |||||
|
| ||||
The buttons on the remote control and the projector's control panel cannot be operated
while the 
indicator is flashing green. Wait until it lights steadily.
The message "No Signal" may appear depending on the projector's menu settings. (p.31)
3 If more than one signal source has been connected, use the remote control or control panel buttons to select the port which the signal source that you would like to use is connected to, while referring to the following table.
Port |
| Button to press | Display at | |
|
|
| screen * | |
| Projector |
| Remote control | |
|
|
|
|
|
INPUT A |
|
| [A] | INPUT A (component) or |
|
| INPUT A (RGB) | ||
|
|
|
| |
|
|
|
|
|
INPUT B |
|
| [B] | INPUT B (component) or |
|
| INPUT B (RGB) | ||
| [INPUT] |
|
| |
|
|
|
| |
S VIDEO |
| [S VIDEO] | S Video | |
|
| |||
|
|
|
|
|
VIDEO |
|
| [VIDEO] | Video |
|
|
|
|
|
D4 VIDEO |
|
| [D4] | D4 Video |
|
|
|
|
|
DVI |
|
| [DVI] | DVI |
|
|
|
|
|
*The display disappears approximately 1 second after the signal is output.
Basic Operations
7