When the Indicators Provide No Help

Condition

Poor image quality

• The image is fuzzy

• Part of the image is out of focus

• The whole image is out of focus

•The image is distorted

•The image contains interference

Probable cause

Remedy

 

 

Has the focus been adjusted correctly?

Adjust the focus. (p.14)

 

 

Has the front adjustable foot been adjusted

Adjust the projection angle. (p.11)

so that the projection angle is too big?

 

If the projection angle is too big, the image will be out

 

of focus vertically.

 

 

 

Is the projector at the correct distance?

The recommended distance from the projector to the

 

screen is within 0.9 - 13 m (2.9 - 42.6 ft). Set up the

 

projector so that the projection distance is within this

 

range. (Setup Guide)

 

 

Is the projector beam perpendicular to the

Adjust the projection angle so that the projector beam

screen?

is perpendicular to the screen. (p.11)

 

 

Is the lens dirty?

Clean the lens. (p.46)

 

 

Has condensation formed on the lens?

Turn off the power and wait for the condensation to

If the projector is suddenly taken from a cold

disappear.

environment to a warm environment, condensation may

 

form on the lens, and this may cause the images to

 

appear fuzzy.

 

Does the input signal setting match the connected source?

Use the “Video Signal”, “INPUT A Signal” or “INPUT

BSignal” commands in the “Signal” menu to select the signal format that matches the connected source. “Signal” - “Video Signal”, “INPUT A Signal”, “INPUT B Signal” (p.30)

Are the cables connected correctly?

Check that all cables that are required for projection are connected correctly. (Setup Guide)

Is an extension cable being used?

Use the accessory cables provided, or connect a signal

If an extension cable is used, electrical interference

amplifier and see if this helps.

may increase.

 

 

 

Have the synchronization , tracking and

Press the [AUTO] button on either the remote control

display position been adjusted correctly?

or the projector's control panel to adjust these settings.

(When connected to a computer)

You can also use the menus to make the adjustment.

 

(p.17, “Image” - “Tracking” , “Sync.” p.28)

 

 

Has the correct resolution been selected?

Set the computer so that the signals that are output are

(When connected to a computer)

compatible with this projector. Refer to the

 

documentation provided with your computer for details

 

on changing the settings. (p.52)

 

 

40