Yamaha LPX-500 manual 62

Front/Top Rear Remote control

Control panel Base

Rear

TRIGGER OUT port	RS-232C port
When the projector power is turned	Connects the projector to a computer using an
on, 12 V DC is output from this	RS-232C cable.
port. When the projector's power is	This port is for service use, and should not
turned off, the output becomes 0 V	normally be used.
to communicate the projector's	D4 VIDEO port (Setup Guide)
power ON/OFF status to an	Inputs component video signals from D ports of
external device.
	AV equipment.other video sources.
Remote control light-
	INPUT B port (Setup Guide)
receiving area
	Inputs analog RGB video signals from a
(Setup Guide)
	computer, and component video signals and
Receives signals from
	RGB video signals from other video sources.
the remote control.
	DVI port (Setup Guide)
Main power switch	Inputs digital RGB video signals from
	a computer.
(p.6)
Press to turn the main
projector’s power on
and off. When the power
is off, the power
consumption is 0 W.

Rear adjustable foot	INPUT A port (Setup Guide)	Rear adjustable foot
Extend and retract to	Inputs component video signals	Extend and retract to
adjust the horizontal	and RGB video signals from other	adjust the horizontal
	video sources.
projection angle.		projection angle.
	VIDEO port
Power inlet (p.6)		S VIDEO port (Setup Guide)
	(Setup Guide)
Connects the power	Inputs composite video signals to	Inputs an S-Video signal to the
		projector from other video sources.
cord.	the projector from other video sources.

Base

Front adjustable foot	Air filter (air inlet) (p.46, 50)
	Prevents dust and other foreign particles from being drawn into the projector.
	When replacing the lamp, replace the air filter also.

Rear adjustable foot Rear adjustable foot

Suspension bracket fixing points (4 points) (p.51, Setup Guide)

Install the optional ceiling mount here when suspending the projector from the ceiling.

Appendices

59