| Adjusting the Image Size |
| Correcting Keystone |
|
|
|
| Distortion |
|
|
|
|
|
|
| Adjusting the Screen Image | Adjusting the Image Angle |
| Displaying a Test |
|
|
| Pattern |
| |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
You can adjust the screen image in order to obtain the best possible picture.
Adjusting the Image Size
The size of the projected image is basically determined by the distance from the projector to the screen. (Refer to the Setup Guide.)
The following procedures explain how to adjust the screen image once the projector itself has been set up.
Procedure | To reduce | Turn the zoom ring on the projector to | |
adjust the image. | |||
| |||
|
|
To enlarge
The image can be enlarged in this way to 1.35 times the normal size.
If you would like to enlarge the image further, move the projector further away from the screen. (Refer to the Setup Guide.)
Operations
Zoom ring
Adjusting the Image Angle
The projector should be as perpendicular to the screen as possible.
If the projector cannot be set up so that it is exactly perpendicular to the screen, it can be set up so that it is tilting slightly horizontally or vertically. To tilt the projector upward, adjust the front adjustable foot to tilt the projector at an angle of up to a maximum 12.9°.
Seen from the side |
| Seen from above | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Basic
Procedure
ExtendRetract
Turn the front adjustable foot underneath the projector to adjust the projector angle.
Turn the front adjustable foot until the desired projection angle is obtained.
•When the foot is adjusted, it may cause the projected images to become distorted. Use the keystone correction function to adjust this distortion. (p.12)
•If the projector is tilted horizontally, turn the rear adjustable feet at left and right to adjust the horizontal angle.
Rear |
|
| Rear |
adjustable foot |
|
| adjustable foot |
Extend | Retract | Extend | Retract |
11