Condition

No images appear (Messages do appear)

“Not Supported” message appears on the screen. “No Signal”message appear on the screen.

Probable cause

Remedy

 

 

Does the input signal setting match the connected source?

Use the “Video Signal”, “INPUT A Signal” or “INPUT B Signal” commands in the “Signal” menu to set the signal format that matches the signal from the connected equipment.

“Signal” - “Video Signal”, “INPUT A Signal”, “INPUT B Signal” (p.30)

Has the correct image input port been selected?

Press the [INPUT] button on the projector's control panel (or the [DVI], [A], [B], [VIDEO] or [S VIDEO] button on the remote control) to change the image source. (p.7)

Is the power for the computer or video source turned on?

Turn on the power. (p.7)

Check the mode which corresponds to the

Refer to the documentation provided with your

frequency of the image signals being output

computer for details on changing the resolution and

from the computer.

frequency of the image signals being output from the

 

computer. (p.52)

 

 

If a laptop computer or a computer with a

Normally image signals are output to only the

LCD screen has been connected to the

computer's LCD screen, so you need to change the

projector, it is necessary to output the image

output to an external destination. For some computer

signals to the projector rather than to the

models, when the image signals are output externally,

they no longer appear on the LCD screen. For details,

screen.

refer to the section of the documentation provided with

 

 

your computer under a heading such as "External

 

output", "Connecting an external monitor" or similar.

 

(p.7)

 

 

Troubleshooting

39