Cleaning

Replacing Consumables

5

Install the new lamp.

Hold the lamp so that it faces the correct way to

 

fit into the projector, and then insert the lamp

 

until it clicks into place and tighten the two fixing

 

screws.

6

Install the lamp cover.

Close the lamp cover, slide it toward the rear of

the projector, and then push the front part downward until it clicks into place.

•Install the lamp securely. For safety, the lamp will turn off automatically when the lamp cover is

opened. Moreover, the lamp will not turn on if the lamp or the lamp cover is not installed correctly.

•Replacement lamps are provided with a spare air filter. The air filter should also be replaced when the lamp is replaced.

•Dispose of used lamps properly in accordance with your local regulations.

Resetting the Lamp Operating Time

The projector has a built-in counter which keeps track of the lamp operating time. When the cumulative operating time reaches a certain point, it causes the replacement warning message to be displayed. Therefore, the counter needs to be reset after the lamp has been replaced with a new one. You can do this using the projector menu.

Do not reset the lamp operating time except after the lamp has been replaced, otherwise the lamp replacement period will not be indicated correctly.

Procedure

1

 

 

Press the [MENU] button on either the

 

 

 

remote control or the projector's

 

 

 

 

control panel.

 

 

 

 

The menu will be displayed.

 

 

Projector

Remote control

 

 

 

2

VideoLamp Source

0H

Select “Lamp” from the “Info” menu.

 

Press the

on either the projector's control

Appendices

 

Input Signal

 

panel or the remote control.

 

 

 

49