PLAYING AND RECORDING

CAUTION

Extreme caution should be exercised when you play back CDs encoded in DTS.

If you play back a CD encoded in DTS on a CD player that does not support DTS, only noise will be heard, and this noise may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player before you play back a CD encoded in DTS.

Playing a source

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SPEAKERS A/B

INPUT selector

 

MAIN ZONE A

 

 

VOLUME

3Press SPEAKERS A and/or SPEAKERS B on the front panel or on the remote control to select speakers A and/or speakers B.

When speaker set A or speaker set B are turned on, SP A or SP B is displayed on the front panel display accordingly (see page 6).

Notes

•When one set of speakers is connected using bi-wire connections, or when using two sets of speakers simultaneously (A and B), make sure SP A and SP B are displayed on the front panel display.

•When listening with headphones, turn off the speakers.

RECEIVER A

Input selector buttons

SPEAKERS A/B

VOLUME +/–

1Press MAIN ZONE A on the front panel (or RECEIVER A on the remote control) to turn on this unit.

2Rotate the INPUT selector on the front panel (or press one of the input selector buttons on the remote control) to select the input source you want to listen to.

4Play the source.

5Rotate the VOLUME control on the front panel (or press VOLUME +/– on the remote control) to adjust the sound output level.

y

You can adjust the tonal quality by using the BASS, TREBLE, BALANCE and LOUDNESS controls, the CD DIRECT AMP switch (R-S700 only), or the PURE DIRECT switch on the front panel (see page 17).

6Press MAIN ZONE A on the front panel again (or RECEIVER A on the remote control) to finish using this unit and set it to standby mode.

16 En