Recording a source
Notes
•Audio signals are not output to the TAPE REC or LINE 1 REC output jacks when TAPE or LINE 1 is selected with the REC OUT selector.
Audio signals are output to both the TAPE REC and the LINE 1 REC output jacks if when PHONO, DOCK, TUNER, CD, SOURCE or LINE 2 is selected with the REC OUT selector.
•This unit must be turned on in order to record.
•The VOLUME, BASS, TREBLE, BALANCE and LOUDNESS controls and the CD DIRECT AMP switch (R- S700 only) and the PURE DIRECT switch have no effect on the source being recorded.
•Check the copyright laws in your country before recording from records, CDs, radio, etc. Recording
REC OUT selector | INPUT selector |
1Rotate the REC OUT selector on the front panel to select the source you want to record.
When SOURCE is selected, the current input source is output.
Note
SIRIUS Satellite Radio broadcasts cannot be recorded.
2Play the source and begin recording using the recording device connected to the REC jacks (TAPE and/or LINE 1) on the rear panel. See page 12.
PLAYING AND RECORDING
Using the sleep timer
Use this feature to automatically set this unit to standby mode after a certain amount of time. The sleep timer is useful when you are going to sleep while this unit is playing or recording a source.
MAIN ZONE A
RECEIVER A
SLEEP
OPERATION | BASIC |
Notes
•The sleep timer can only be set with the remote control.
•The sleep timer automatically turns off Zone 2. However, Zone 2 components are not turned off.
1Press SLEEP repeatedly to set the amount of time before this unit is set to standby mode.
Each time you press SLEEP, the front panel display changes as shown below.
The SLEEP indicator blinks while setting the amount of time for the sleep timer.
If the sleep timer is set, the SLEEP indicator on the front panel display lights up.
y
•To disable the sleep timer, select “Sleep Off”.
•The sleep timer setting can also be canceled by pressing RECEIVER Aon the remote control (or MAIN ZONE Aon the front panel) to set this unit to standby mode.