9PRESET j / i

Selects a preset FM/AM station when TUNER is selected as the input source (see page 24).

Selects a preset SIRIUS channel when SIRIUS is selected as the input source (see page 31).

0FM/CATEGORY l, AM/CATEGORY h

Sets the FM/AM tuner band to FM or AM when TUNER is selected as the input source (see page 20).

Selects a channel category when SIRIUS is selected as the input source (see page 29).

ATUNING/CH jj / ii

Selects the tuning frequency when TUNER is selected as the input source (see page 20).

Searches for a SIRIUS channel when SIRIUS is selected as the input source (see page 29).

BRemote control sensor

Receives infrared signals from the remote control.

Note

Switch the remote control ID between ID1 and ID2 when using multiple Yamaha receivers or amplifiers (see page 44).

CZONE 2

Turns on Zone 2 or sets ZONE 2 to standby mode. When Zone 2 is turned on, signals are output to the ZONE 2 OUT jacks (see page 45).

DZONE 2 CONTROL

Allows buttons and controls on the front panel to be used to control Zone 2. For more information about controlling Zone 2, see page 46.

ECD DIRECT AMP and indicator (R-S700 only)

Allows you to listen to a CD source in the purest possible sound (see page 17). The indicator lights up and the front panel display turns off when this function is turned on.

Notes

•If both the CD DIRECT AMP and the PURE DIRECT are turned on, only the CD DIRECT AMP will function.

•Zone 2 cannot be used while this function is turned on.

FPURE DIRECT and indicator

Allows you to listen to a source in the purest possible sound (see page 17). The indicator above it lights up and the front panel display turns off when this function is turned on.

Note

Zone 2 cannot be used while this function is turned on.

GPHONES jack

Outputs audio to your headphones for private listening.

Note

Press SPEAKER A/B so that the SP A/B indicators turn off before you connect your headphones to the PHONES jack.

CONTROLS AND FUNCTIONS

HREC OUT selector

Selects a source for recording to a CD recorder or to a tape deck independently of the INPUT selector setting, allowing you to record the selected source while listening to another source (see page 19).

IBASS control

Increases or decreases the low frequency response. The center position produces a flat response (see page 18).

JTREBLE control

Increases or decreases the high frequency response. The center position produces a flat response (see page 18).

KBALANCE control

Adjusts the sound output balance of the left and right speakers to compensate for sound imbalances caused by speaker locations or listening room conditions (see page 18).

LLOUDNESS control

Retains a full tonal range at any volume level to compensate for the human ears’ loss of sensitivity to high and low-frequency ranges at a low volume level (see page 18).

MINPUT selector

Selects the input source you want to listen to.

NVOLUME control ( R-S700 only)

Increases or decreases the sound output level.

Note

This does not affect the output level of the REC jacks.

INTRODUCTION

5 En