Yamaha X-V2600 owner manual Using the control mode of Zone 2 and Zone, 118

ZONE 2/ZONE 3

■Adjusting the volume level of Zone 2 or

Zone 3

Rotate VOLUME on the front panel (or press VOLUME +/– on the remote control) to adjust the volume level of the selected zone.

Control range: –80 dB to +16.5 dB

Control step: 0.5 dB

VOLUME

+

or VOLUME

–

Note

VOLUME +/– can be used only when Zone2 Volume or Zone3 Volume is set to Variable in Multi Zone (see page 97).

y

Press MUTE to mute the sound output to the selected zone.

■Adjusting the tonal quality of Zone 2 or

Zone 3

Press CH +/– and TV VOL +/– on the remote control to adjust the high-frequency response (TREBLE) and the low-frequency response (BASS) respectively.

Control range: –10 dB to +10 dB

Control step: 2 dB

++

CH TV VOL

––

Note

Check that “ZONE 2” or “ZONE 3” is displayed in the display window of the remote control before you adjust the tonal quality of the corresponding zone (see page 117).

y

You can also adjust the tonal quality of Zone 2 or Zone 3 by using TONE CONTROL on the front panel. For details, see “Adjusting the tonal quality” on page 39.

■Displaying the Zone 2 on-screen display

Use the Zone2 OSD parameter to display the operational status of Zone 2 as well as Zone 3 on the Zone 2 video monitor connected to the ZONE 2 VIDEO jacks on the rear panel of this unit. For detailed information on the Zone2 OSD parameter, see page 97.

Using the control mode of Zone 2 and Zone 3

POWER and STANDBY on the remote control work differently depending on the selected zone that appears in the display window.

•When the normal, Zone 2 or Zone 3 mode is selected, you can turn on this unit, Zone 2 or Zone 3 or set them to the standby mode individually.

•When the all mode is selected, pressing POWER turns on this unit, Zone 2 and Zone 3 simultaneously and pressing STANDBY sets them to the standby mode simultaneously.

		POWER
Control mode	LCD display	and
		STANDBY
Normal mode		Turns on the main
	Name of component	unit only or sets it to
		the standby mode.
Zone 2 mode	“ZONE 2” or “2:name	Turns on Zone 2 or
	of the selected	sets it to the standby
	component”	mode.
Zone 3 mode	“ZONE 3” or “3:name	Turns on Zone 3 or
	of the selected	sets it to the standby
	component”	mode.
		POWER: turns on
		the main unit, Zone 2
All mode		and Zone 3.
	“ALL”	STANDBY: sets the
		main unit, Zone 2
		and Zone 3 to the
		standby mode.

Note

In the normal mode, MAIN appears for a few seconds when POWER or STANDBY is pressed.

118