Yamaha X-V2600 Selecting Zone 2 or Zone, 116, Using the internal amplifiers of this unit

ZONE 2/ZONE 3

■Using the internal amplifiers of this unit

If you want to use one internal amplifier (surround or surround back) of this unit

Connect the Zone 2 or Zone 3 speakers directly to the SURROUND/ZONE 2(3) or PRESENCE/ZONE 2(3) terminals and select either INT:Sur. or INT:PRNS for Zone2 Amplifier (see page 96).

If you want to use two internal amplifiers (both surround and surround back) of this unit

Connect the Zone 2 or Zone 3 speakers directly to the SURROUND/ZONE 2(3) and PRESENCE/ZONE 2(3) terminals and select INT:Both for Zone2 Amplifier or Zone3 Amplifier (see page 96).

Third room

		SURROUND/ZONE 2(3)
R	+	–	–	+	L	R	L
						+
R +		–	–	+ L
						–
						PRESENCE/ ZONE 2(3)
			SINGLE
		SURROUND BACK

Second room

This unit

IMPORTANT SAFETY NOTICE

SURROUND/ZONE 2(3) or PRESENCE/ZONE 2(3) speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or more than one loudspeaker per channel.

Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low impedance load resulting in amplifier damage. See this owner’s manual for correct usage.

Compliance with minimum speaker impedance information for all channels must be maintained at all times. This information is found on the back panel of your Receiver.

Selecting Zone 2 or Zone 3	2 Press ZONE CONTROL on the front panel
You can select the zone you want to control by using the	repeatedly to select the zone you want to
	control.
control buttons on the front panel or on the remote control.
Once the zone you want to control is selected, you can	ZONE CONTROL
control the selected zone as described in “Controlling
Zone 2 and Zone 3” on page 117.

■Front panel operations

1Press MAIN ZONE ON/OFF, ZONE 2 ON/OFF or ZONE 3 ON/OFF on the front panel to individually turn on this unit, Zone 2 or Zone 3.

Press each button repeatedly to turn on the respective zone or set it to the standby mode.

ZONE ON/OFF

ON/OFF

ZONE ZONE

y

Once MASTER ON/OFF on the front panel is pressed inward to the ON position, you can also press POWER and STANDBY on the remote control to turn on this unit, Zone 2 and Zone 3 simultaneously.

Each time you press ZONE CONTROL, the front panel display changes as shown below, and the indicator for the currently selected zone flashes for approximately 5 seconds. However, no indicator flashes when this unit is selected.

ZONE2 ZONE3

No indicator flashes when this unit is selected.

ZONE2

Controls the Zone 2 component connected to the ZONE 2 AUDIO L/R jacks on the rear panel of this unit.

ZONE3

Controls the Zone 3 component connected to the ZONE 3 AUDIO L/R jacks on the rear panel of this unit.

116