Yamaha X-V2600 owner manual Input Select, Antenna Level Antenna level

SYSTEM OPTIONS

Input Select

Use this feature to reassign digital input/outputs, select the input signal, rename the inputs, or adjust the level of the signal input at each jack.

Choices: XM, TUNER, PHONO, CD, CD-R, MD/TAPE, DVD, DTV, CBL/SAT, VCR1, DVR/VCR2,

V-AUX, MULTI CH

Note

Some parameters described below may not be available for all input sources and some parameters are only available for specific input sources.

Input source	Parameter
	Antenna Level
XM	Volume Trim
	Rename
TUNER	Volume Trim
	Rename
PHONO
CD
CD-R	I/O Assignment
MD/TAPE	Audio Select
DVD	Decoder Mode
DTV	Volume Trim
CBL/SAT	Rename
VCR1
DVR/VCR2
	Audio Select
V-AUX	Decoder Mode
	Volume Trim
	Rename
MULTI CH	Volume Trim
	Multi CH Assign

1Set AMP/SOURCE/TV to AMP and then press GUI TOP on the remote control.

The top display appears.

AMP	GUI TOP
SOURCE	TITLE
	BAND
TV

Stereo/Surround	Sound
Input Select	Video
Manual Setup	Basic
Auto Setup	Option
System Memory

2Select Input Select and then press h.

	CD-R
Stereo/Surround	MD/TAPE
Input Select	DVD
Manual Setup	DTV
Auto Setup	CBL/SAT

3Select the desired input source (CD, DVD, etc.) and then press h to access and adjust.

■Antenna Level (Antenna level)

Use to display the XM Satellite Radio reception level.

Input Select > XM > Antenna Level >

Display status: NONE, 0 to 100%

Antenna Level 100%

Antenna Level

Volume Trim

Rename

•If the displayed percentage of the reception level is below the average (approximately 60%), you need to adjust the orientation of the XM Satellite Radio antenna for a better percentage of the reception level.

•If NONE is displayed, the XM Satellite Radio antenna may not be firmly connected to the XM jack on the rear panel of this unit. Check the XM Satellite Radio connection.

Note

The Antenna Level parameter cannot be adjusted by using the remote control. Instead, you need to adjust the orientation of the XM Satellite Radio antenna for a better percentage of the reception level.

80