Yamaha X-V2600 owner manual Connecting an external amplifier, Notes, 1FRONT PRE OUT jacks

CONNECTIONS

■Connecting an external amplifier

If you want to increase the power output to the speakers, or want to use another amplifier, connect an external amplifier to the PRE OUT jacks as follows.

Notes

•When audio pin plugs are connected to the PRE OUT jacks for output to an external amplifier, it is not necessary to use the corresponding SPEAKERS terminals. Set the volume of the external amplifier connected to this unit to the maximum.

•The signal output at the FRONT PRE OUT and CENTER PRE OUT jacks are affected by the TONE CONTROL settings.

•If SPEAKERS A is turned off and SPEAKERS B is set to Zone B (see page 95), signals will only be output at the FRONT PRE OUT jacks.

1

FRONT

PRE OUT

2

3

4

RL

SURROUND

RL

SUBWOOFER CENTER

SINGLE (SB)

RL

SURROUND BACK/PRESENCE

5

1FRONT PRE OUT jacks

Front channel line output jacks.

2SURROUND PRE OUT jacks

Surround channel line output jacks.

3SUBWOOFER PRE OUT jack

Connect a subwoofer with built-in amplifier, such as the YAMAHA Active Servo Processing Subwoofer System, to this jack.

4SURROUND BACK/PRESENCE PRE OUT jacks

Surround back or presence channel line output jacks. If you only connect one external amplifier for the surround back channel, connect it to the left (L) jack.

5CENTER PRE OUT jack

Center channel line output jack.

Notes

•Each PRE OUT jack outputs the same channel signal as the corresponding speaker terminals. However, when both surround back and presence speakers are setup in this unit, the signals output at SURROUND BACK/PRESENCE PRE OUT jacks may not correspond to the correct speakers.

•Adjust the volume level of the subwoofer with the control on the subwoofer.

•Some signals may not be output at the SUBWOOFER PRE OUT jack depending on the Speaker Set settings (see page 90).

28