Yamaha X-V2600 owner manual 10 mm 3/8, Speaker terminal wrench Red positive + Black negative

CONNECTIONS

1Remove approximately 10 mm (3/8 in) of insulation from each of the speaker cables.

10 mm (3/8 in)

2Twist the exposed wires of the cable together to prevent short circuits.

3Loosen the knob using the supplied speaker terminal wrench.

Speaker terminal wrench

Red: positive (+)

Black: negative (–)

4Insert one bare wire into the hole on the side of each terminal.

Red: positive (+)

Black: negative (–)

5Tighten the knob to secure the wire using the supplied speaker terminal wrench.

Speaker terminal wrench

Red: positive (+)

Black: negative (–)

6Hook the speaker terminal wrench onto WRENCH HOLDER on the rear panel of this unit when not in use.

16