Yamaha X-V2600 owner manual Changing parameter settings, Press Exit

Changing parameter settings

Use the remote control to access and adjust each parameter. (Speaker set is used in the following example to change parameter settings.)

Manual Setup > Basic > Speaker Set >

	+	+	+	AMP
					1
				SOURCE
	TV VOL	CH	VOLUME
	–	–	–	TV
	TV MUTE	TV INPUT	MUTE
1	GUI TOP	PRESET/CH	EXIT	PURE DIRECT	5
	TITLE		MENU
	BAND		SRCH MODE
				NIGHT
		ENTER		AUDIO	2-4
			A-E/CAT.
				STRAIGHT
	RETURN		DISPLAY
	XM MEMORY			EFFECT

1Set AMP/SOURCE/TV to AMP and then press GUI TOP on the remote control.

The top display appears.

AMP	GUI TOP
SOURCE	TITLE
	BAND
TV

SYSTEM OPTIONS

3Press k / n repeatedly to select the parameter you want to adjust.

Presence	40Hz
Bass Out	60Hz
Bass Cross Over	80Hz (THX)
SWFR Phase	90Hz
	100Hz

4Press ENTER or h and then press k / n repeatedly to change the setting of the item you want to adjust.

Presence	40Hz
Bass Out	60Hz
Bass Cross Over	80Hz (THX)
SWFR Phase	90Hz
	100Hz

Stereo/Surround	Sound
Input Select	Video
Manual Setup	Basic
Auto Setup	Option
System Memory

2Press k / n repeatedly to select a menu and then press h to enter the selected menu.

Test Tone
Speaker Set	Front
Speaker Distance	Center
Speaker Level	Surround

Front
Center	Large
Surround	Small
Surround Back	None
Presence

5Press EXIT.

y

If you want to continue adjusting parameter settings, press ENTER to return to the previously selected menu item.

Notes

•The available parameters may be displayed on more than one page of the GUI display. To scroll through pages, press k / n.

•You cannot change parameter values when Memory Guard is set to “On”. If you want to change the parameter values, set Memory Guard to “Off” (see page 98).

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cable is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the parameter values will return to the factory settings. If this happens, edit the parameter value again.

OPERATION ADVANCED

79