Installation instructions

General information

The YLCC water chillers and heat pumps are factory-charged and tested packaged units.

Inspection

Upon reception, inspect the goods and notify the carrier and the insurance company, in writing, of any possible damage during transportation.

Environmental protection

Packing

Packing is made of recyclable material. Its elimination should be carried out in accordance with local regulations on selec- tive collection of residual material.

Elimination of the unit

Upon disassembly of the unit after a long service life, the components should be recuperated ecologically. The cooling circuit is full of refrigerant, which should be recuperated and returned to the gas manufacturer for recycling.

Oil will remain in the hermetic compressor and, therefore, must be returned with its circuit sealed.

The air conditioning unit will be deposited in an area deter- mined by the local authorities, for its selective recuperation.

Warning signs

The following signs indicate the existence of potentially dan- gerous conditions for users or servicing personnel. Whenever found on the unit itself, take the meaning of each one into account.

This symbol indicates an electrical danger or risk.

Attention: It is obligatory to read the in- structions prior to any handling.

Attention: Fan in operation.

Attention: Do not touch hot surfaces.

Attention: The unit is equipped with re- mote control and can start automati- cally. Two minutes prior to having ac- cess to the interior, disconnect the power supply so as to avoid any con- tact with the fan turbine in motion.

Attention: Lifting point.

Transportation

The units should always be transported in vertical position so as to avoid oil leaking out of the compressor. If, for any reason, this position need be changed sporadically, they will remain in that position a strictly necessary period of time only. To move the units to their final location, the four rectangular openings in the bed frame can be used with a forklift truck, or the four cylindrical holes at the ends of the bed frame for elevation.

YLCC

YLCC-H

21

Page 21
Image 21
York YLCC-h, YLCC 42/62/82/102/112, 122, 152 manual General information, Inspection, Environmental protection, Transportation