Zebra Technologies TTP 7030 technical manual Black Mark Size and Position

114

Specifications

Paper Specification

Black Mark Size and Position

See also Page Setup on page 85.

Print side	Inner side (opposite to thermal coating side)
Sensor position	25 mm before cutter, and 9.1 mm from left edge of ticket
	entry when seen from the front of the printer (on the side of
	the blue release arm).
Mark length range	3 to 18 mm, default 5 mm
Mark width	Minimum 5 mm centered on the sensor position,
	recommended width is 9 mm
Print density	Standard wet offset mode is recommended for printing of the
	black-marks. The full mark area must be printed. Screen-
	printing is not allowed. Measurement of print density must be
	performed relative to the white paper background.
	Using a MacBeth densitometer, the print density must be
	greater than 1.3. Anti-gloss filter is not allowed. Using a
	Gretag densitometer, the print density must be greater than
	1.5. The reflection from the black-mark must be less than
	10%. The reflection from the paper must exceed 80%.
Preprinting	Preprinting in the zone passing over the black-mark sensor is
	not recommended. If required, OCR blind type of ink must be
	used, (outside the 700-1100 nm range).
Punched holes	Punching must be done from the thermally coated side. Distorted
	print can be expected within a zone of approximately 2-mm
	around the edges of the hole. The function must be tested.

P1003636-002 TTP 7030™ Technical Manual 10/05/2009