Zebra Technologies TTP 7030 Print Setup, Current consumption, Disable the loop, Cm loop

76

Default Parameter Settings

Print Setup

Print Setup

7	5	Default	Burn Time	DRV
	1	Min
	15	Max

Note • DRV indicates that, when using Windows, the driver takes over this setting so please set appropriate value in the driver properties/document defaults.

A long burn time gives darker print. On insensitive paper types you may have to increase the burn time to get an acceptable print quality.

8	17	Default							Max Print Speed1											DRV
	1	Min
	17	Max
			The main reason to decrease the print speed is to enhance print quality, and to reduce the peak
			current consumption.
			n	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	17
			mm/s	21	27	32	37	41	45	48	52	55	57	60	63	66	68	71	73	75

Note • Some settings result in printer chassis resonance causing excessive noise and deteriorated print quality. If this happens, increase the print speed.

9	15	Default	Presenter Loop Length
	3	Min
	255	Max

Limits the maximum loop length. When the set length is reached, the printer ejects part of the printout and continues too print. You use this when you have very limited space for the loop inside the kiosk. Each step represents a 3.2-cm increment.

Setting the parameter to 0 disables the looping and feeds the paper straight out.

<ESC>&P<9><0>	Disable the loop
<ESC>&P<9><7>	16 cm loop
<ESC>&P<9><15>	48 cm loop

P1003636-002 TTP 7030™ Technical Manual 10/05/2009