Zebra Technologies TTP 7030 technical manual Angle, Cut the paper in a suitable angle. See Figure

Operation

Installing a Paper Roll

4.Cut the paper in a suitable angle. See Figure 11.

Figure 11 • Suitable paper edge for auto load

70º	Cut off at	90º
	a 70º-90º
Thermal side (top)	angle	Thermal side (top)

25

Note • The paper sensor is on the same side as the blue paper release lever (where the arrow points in Figure 12, Insert the New Paper, on page 25). If the paper is cut in a direction opposite to that as shown in the figure above, the sensor will not detect the paper.

5.Insert the paper through the paper entry opening at the back of the printer.

The printer will now feed, cut and eject a printout, and then automatically go on-line.

Note • In high temperature and high humidity, the paper may lose its stiffness resulting in paper jam at automatic paper loading. In such cases, load paper manually.

Figure 12 • Insert the New Paper

10/05/2009 TTP 7030™ Technical Manual P1003636-002