Zebra Technologies TTP 7030 technical manual Upc

42

Programming

Barcode Commands

ESC B S n1...		n11		Barcode Field Specify
1B 42 53 n1	...n11		hex
27 66 83 n1...	n11		decimal

Bar codes can only be printed in portrait mode unless Fixed Document Mode is selected with parameter n36.

The command reserves an information field as a bar code field. The command also identifies the type, number of digits, and the configuration of bars to be placed in the bar code field.

n1	Specifies the bar code field No. (0—15). Bar code fields may be
	specified in any order.
n2n3	Sets the X coordinate of the bar code field origin (n2 is the higher-order
	and n3 the lower-order byte).
	n2 and n3 must be 1-byte hexadecimal or decimal numbers. The values
	must not place the bar code outside the total pixel count that can be
	handled by the printer.
n4n5	Must be specified but the values are discarded by the printer.
n6	Specifies the number of bar code digits, but is ignored by the printer.
n7n8	Specifies the height of the bars.
n9	Specifies the type of bar code. The following types are supported.
n9 = 0	EAN 8 or 13 (auto detect). The printer calculates the necessary check
	digit.
n9 = 1	UPC
b9 = 2	2/5 Interleaved (even number of characters must be sent)
n9 = 3	ISBN
n9 = 4	Code128 (Start data string with C2h (FNC1) to encode EAN128)
n9 = 6	Code39
n10	Specifies the thickness of the narrow bar 0=1 pixel, 1=2 pixel, and so on.
n11	Specifies the wide-bar-to-narrow-bar ratio. Only used in Code 39 and 2-
	of-5 interleaved where different ratios are allowed

P1003636-002 TTP 7030™ Technical Manual 10/05/2009