
Default Parameter Settings
Print Setup
10 | 1 | Default | Print Head Pulse Control |
0 | Min | ||
| 3 | Max |
|
Controls what the printer does with buffered data:
77
<ESC>&P<10><0> | 1 burn pulse + history |
<ESC>&P<10><1> | 1 burn pulse |
<ESC>&P<10><2> | 2 burn pulses + history |
<ESC>&P<10><3> | 2 burn pulses |
Adding history pulse enhances print quality. Dividing burning into two burn pulses reduces the peak current consumption.
13 | 0 | Default | Line Spacing |
0 | Min | ||
| 30 | Max |
|
The line spacing is normally set by the font height. With this parameter you can set a line spacing that is higher that the font height. Line spacing settings lower than the font height will be ignored.
<ESC>&P<13><30>
30 pixels or font height, whichever is the largest
14 | 0 | Default | Font Selection |
0 | Min | ||
| 7 | Max |
|
Store which font number is used if no font is specified. Font is selected using Font Selection on page 77 . Selecting an invalid font gives a software error status message (invalid index).
15 to 30 | - | Default | Tab Stop |
1 | Min | ||
| 255 | Max |
|
Stores 16 different TAB stop positions. The position is set in increments of
Tab position 255 sets a tab stop on the last position of the line. Use this if you want underline or reversed text to extend across the full paper width.
To set all tab stops at once, follow the procedure Set several parameters at once on page 55 . To move a single tab stop, use the set parameter command <ESC>&P.
Example • This example sets the first tab stop 25 mm from the left margin.
<ESC>&P<15><10>
Default positions are one TAB on each cm; that is parameter values 4, 8, 12 etc.
10/05/2009 | TTP 7030™ Technical Manual |