Zebra Technologies TTP 7030 technical manual Under Summary Of Parameter Settings on

62

Programming

Status Reporting Commands

ESC ENQ c		Device ID Enquiry
1B 05 63	hex
27 5 99	decimal

Results in a string containing the device ID in the Windows Plug and Play string format. The two first bytes represent the string length.

Example •

Send→ <ESC><ENQ><99>

Read← 0 106 This indicates that the string is 104 characters (plus two characters indicating the string length)

Read←”MANUFACTURER:Zebra;COMMAND

SET:None;MODEL:TTP7020;CLASS:PRINTER;DESCRIPTION:Ticket

Printer TTP7020;”

Note • The string shown here is just an example. Read out the actual string from your printer.

ESC ENQ P n1

1B 05 50 n1	Hex
27 5 80 n1	Decimal

Parameter-setting Data Enquiry

This command requests information about the setting of parameter n1, that is, the parameter value stored in flash PROM or any parameter value temporarily set by other ESC commands.

n1= 1	gives the setting of parameter 1, etc.The parameter names are listed
	under Summary Of Parameter Settings on page 72 .
n1 = 0	gives a response where the first two bytes specifies the length of data to
	come (high-byte, low byte), and followed by a block of data for all
	parameters in the temporary setup.

P1003636-002 TTP 7030™ Technical Manual 10/05/2009