
48
Programming
Print Commands
Print Commands
ESC p
1B 70 | Hex |
27 112 | Decimal |
This command makes the printer print the contents of the line buffer.
Text is converted from text to pixel lines and stored in the line buffer when an LF is received. If the line buffer is empty when <ESC>p is received, nothing is printed.
Text to be printed <LF><ESC>p prints "Text to be printed" on the paper.
Printout is effected automatically at:
Cut | <S> and <ESC><RS> |
Form feed | <FF> |
Clear presenter | <ENQ> |
Run presenter | <ESC><FF><n> |
Print buffer full |
|
|
|
Press on |
|
|
|
ESC P n1
1B 50 n1 | Hex |
27 80 n1 | decimal |
Print
This command makes the printer generate a
n = 0
n = 1
Gives standard
Gives a character set printout using the font selected by parameter p14.
| ESC J n1 |
| Paper Advance* | ||
| 1B | 4A n1 | hex |
| |
27 | 74 n1 | decimal |
|
| |
|
|
|
|
|
|
*. DO NOT use ESC J n, ESC j n, or ESC Q n in fixed page mode
The value n represents the number of dot lines the paper is to be transported forwards. Range:
A dot line is 0.125 mm, and 255 dot lines equal approximately 32 mm.
| TTP 7030™ Technical Manual | 10/05/2009 |