Zebra Technologies TTP 7030 technical manual ESC g n1 Print Logotype

Programming

Graphics Commands

47

ESC g n1...		n5	Print Logotype
1B 67 n1...	n5	hex
27 103 n1...	n5	decimal

Prints a customized logotype2 stored in the flash PROM. See also Logotypes on page 66.

n1

n2n3

n4n5

One-byte logotype identification No. (0—15)

Two-byte definition of desired print position in X-direction measured from left-hand edge of the page (see Printable Area on page 86 regarding definition of “page”). X-direction is perpendicular to the paper transport direction.

Two-byte definition of desired print position in Y-direction. In variable document mode the Y-position is ignored. The resolution is 0.125mm in both X and Y directions

ESC L n1			Print Logotype at Current Position
1B	4C n1	Hex
27	76 n1	Decimal

Prints a customized logotype stored in the flash PROM at the position of the cursor. The bottom line of the logotype is positioned at the baseline of the text on the line. If the logotype is higher than the text, the line spacing is increased.

See also Logotypes on page 66.

n

One-byte logotype identification No. (0—15)

2. For logotype loading, see ESC & 1 on page 53.

10/05/2009 TTP 7030™ Technical Manual P1003636-002