Hook Up an Off Air Antenna with VCR
Connect an over-the-air signal source to the VCR and TV
Over-the-Air Antenna with VCR
1Locate the Antenna/Cable In jack on the back of the VCR.
2
3
Connect the antenna that runs from the wall jack directly to this jack, according to the connection diagram shown to the right.
Make the VCR to TV connections as indicated in the illustration.
Antenna |
VCR Back
If you have a 75 ohm RF cable, then you don’t need any adapters!
A 300 to 75 ohm adapter is not included with the Zenith TV.
No A/V cables are included with the TV.
RF Coaxial Wire (75 ohm)
VCR Back AV Panel
In output 
switch 3 4
Out Video Audio
Typical
TV Back
Antenna
Cable
TV SPEAKER
A/V cables not included with TV
M.P.I. | VIDEO IN SPEAKER OUT |
| PILLOW SPEAKER |
| AUDIO IN |
Page 10 |
