![](/images/new-backgrounds/1305479/305479109x1.webp)
LT2002 Clone Programmer
Clone Operation Notes
Disconnect the Clone from the TV when you are finished; automatically switching it off. The real- time clock continues to run after the main circuits are switched off.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the pro- grammer behaves strangely after a static shock, use a paper clip or similar instrument inserted through the small hole marked ”RESET” to activate the internal reset switch and restore normal opera- tion.
After a reset, check the
The LT2002 programmer is designed to be used with TV's containing the
Clone Programmer/Cloning Procedure Troubleshooting
Problem | Possible Cause(s) | Possible Solution(s) |
|
|
|
Clone Programmer |
|
|
LED does not blink. | • M.P.I. cord not connected. | - Connect M.P.I. cord. |
| • TV not turned On. | - TV must be On for clone to work. |
| • Weak batteries. | - Install 4 fresh AA |
|
| batteries. |
Clone menu hard | • Weak signal. | - Connect TV to a reliable signal Source. |
to read. |
|
|
No time set. | • No time on Master TV. | - Set time on master TV, copy time to Clone |
|
| Programmer. |
Menu items | • Not necessary. | - Channel Labels already cloned; if they were |
on clone selection menu. |
| on Master TV. |
|
|
|
Master and Other TV's |
|
|
Cloning did not work. | • Procedure interrupted. | - Wait until procedure complete message is |
|
| displayed. |
| • Different TV models. | - Cloning is only possible with identical model |
|
| Zenith TV's. |
Clone time disappeared. | • Batteries were removed. | - Batteries must remain installed to retain time |
|
| settings. |
New Setup not present. | • TV not reset. | - Disconnect |
|
| 15 seconds. |
Digital information not | • | - Redo setup and |
present. |
|
|
When cloning operations are complete, just unplug the LT2000 from the TV.
If the TV does not display a picture (blank screen) after a few seconds, just change channels.
Page 55 |