Hook Up an Off Air Antenna

Connect an over the air signal source to the TV

Over-the-Air Antenna

1Locate the Antenna/Cable jack on the back of the TV.

2Connect the RF antenna wire that run from the wall directly to the jack, according to the connection dia- gram shown to the right.

If you have a 75 ohm RF cable, then you donÌt need any adapters!

A 300 to 75 ohm adapter is not included with the Zenith

TV.

Typical

TV Back

Antenna

RF Coaxial Wire (75 ohm)

Antenna

Cable

 

TV SPEAKER

M.P.I.

VIDEO IN SPEAKER OUT

 

PILLOW SPEAKER

 

AUDIO IN

Mini Glossary

75 ohm

The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex

RF Cable

shaped nut with a wire sticking through the middle, and it screws onto the threaded jack on the

 

back of the TV.

300 to

(Not shown) A small device that connects a flat two-wire 300 ohm antenna to a 75 ohm RF jack.

75 ohm

They are usually about an inch long with two screws on one end and a round opening with a

Adapter

wire sticking out on the other end.

Page 8

206-4065

Page 8
Image 8
Zenith H20J55DT warranty Hook Up an Off Air Antenna, Connect an over the air signal source to the TV, Over-the-Air Antenna