LT2002 QuickSet Programmer
Cloning Preparations
Before You Begin Cloning...
•Only use one MPI port for connecting to MPI equipment.
•Do not run Auto Program while TV is connected to clone programmer.
•The “master TV” should be connected to a good, stable signal from an over-
•Teaching and Learning is only possi- ble between identical model Zenith TV's. (However, the Clone programmer can store 3 different master TV setups.)
WARNING: Copying a blank or incorrect memory into a TV will cause 
the TV to operate erratically or
become inoperable.
•Use a typical Zenith HealthView Installer remote or the Installer remote shown on page 16 to operate Learning and Teaching menus.
•Make sure that the batteries in the Clone programmer are fresh.
•If the batteries are removed, the Clone Clock time will be lost.
•Decide if you want to set the time from the Clone programmer or copy the time to the Clone programmer; from a TV which has the clock set to the cur- rent time.
•Follow the connection diagrams on the previous page to connect the Clone to a master TV and, after learning is complete, to another TV to “teach” it the setup.
•Setting the time and transferring it to the Clone or another TV is a separate procedure.
•Once a TV’s setup is copied to anoth- er TV, the target TV needs to be discon- nected from power for about 15 sec- onds to activate the
•See Troubleshooting to solve prob- lems.
A. Set Up a Master TV
Using the installer remote shown on page 16, set up a “Master” TV with cus- tom settings and features as described in the TV’s operating guide.
The master TV’s Setup is what you will copy to the Clone Programmer and transfer to TV's with the same model number so they will operate identically.
B. Connect Clone to Master TV
If there is a good connection, the “Clone has Control of the TV” message will appear on the TV screen. ( See menu on the previous page.)
Cloning capability of a Master TV setup is restricted to channels displayed in Physical channel scanning mode. For Physical Channel Scan, leave Installer Menu item
A slow flashing green light indicates there is a problem with the communica- tions between the TV and the programmer. In this case, check for a damaged cable, poor contacts or other connection troubles.
If the status indicator is red, the programmer batteries are low and should be replaced. Use 4
Page 53 |
