Figure 8-8 Menu 12.4 - Bridge Static Route

1.Route Name - For identification purposes enter a name for the bridge static route.

2.Active - Indicates whether the static route is active or not.

3.Ether Address -Enter the MAC address of the destination device that you wish to bridge your packets to.

4.IP Address - If available, enter the IP address of the destination device that you wish to bridge your packets to.

5.Gateway Node - Enter the number (1-4) of the Remote Node that is linked to this static route. When an incoming packet’s destination Ether (MAC) address matches the value entered above, then it will trigger a call to this Remote Node.

Once you have completed filling in the menu, press ENTER at the message: Press ENTER to Confirm ... to save your selections, or press ESC at any time to cancel your selections.

Bridging Configuration 65

Page 77
Image 77
ZyXEL Communications 128L user manual Menu 12.4 Bridge Static Route