∙CHAP/PAP - Your Prestige will try CHAP when CHAP is requested by the Remote Node or PAP when PAP is requested by the Remote Node.
∙CHAP - Use CHAP only.
∙PAP - Use PAP only.
8.Route - This field determines the protocols that your Prestige will route. The choices for this field are determined by the features that are enabled.
9.Bridge - Bridging is used for protocols that are not supported or not turned on in the previous Route field, e.g., SNA. When bridging is enabled, your Prestige will forward any packet that it does not recognize to this Remote Node; otherwise, the unrecognized packets are discarded. The disadvantage of bridging is that it usually generates large amounts of traffic. Press the space bar to select either Yes or No.
10.Edit PPP Options - To edit the PPP options for this Remote Node, move the cursor to this field, use the space bar to select Yes and press ENTER. This will bring you to Menu 11.2 - Remote Node PPP Options For more information on configuring PPP options, see the section Editing PPP Options.
11.IP Addr - This is a required field if Route is set to IP. Enter the IP address of this Remote Node.
12.Edit IP/IPX/Bridge Options - To edit the parameters of the protocols, go to this field, select Yes and press ENTER. This will bring you to Menu 11.3 - Remote Node Network Layer Options. For more information on filling out this screen, refer to the chapter pertaining to your specific protocol.
13.Session Option: Input Filter Sets and Output Filter Sets - In these fields, select which filter set(s) you would like to implement to filter the incoming and outgoing traffic between this Remote Node
