ZyXEL Communications 1600 15.4.3 Example - Using the FTP command from the DOS Prompt, Login Type, Host Address, Transfer Type, Initial Local Directory, Initial Remote Directory

Prestige 1600 Universal Access Concentrator

Menu 24.7.1 – Upload ZyNOS code using FTP

To upload the router firmware, follow the procedure below:

1.Launch the FTP client on your workstation.

2.Type “open” and the IP address of your Prestige. Then type “root” and your SMT password as requested.

3.Type “put firmwarefilename ras-m” where “firmwarefilename” is the name of your firmware upgrade file on your workstation and “ras-m” is the remote file name on the Prestige. Specify “ras-m” as the remote filename if you want to upload firmware from your workstation into the main block or “ras-b” if you want to upload firmware into the backup block.

4.The system reboots automatically after a successful firmware upload.

For details on FTP commands, please consult the documentation of your FTP client program. For details on uploading router firmware using TFTP (note that you must remain in menu 24.7.1 to upload router firmware using TFTP), please see the Prestige manual.

Press ENTER to Exit:

Figure 15-10 Menu 24.7.1 as seen using Telnet

15.4.3 Example - Using the FTP command from the DOS Prompt

Use “put” to transfer files from the workstation to the Prestige, e.g., put prestige.bin ras transfers the firmware on your computer (“prestige.bin”) to the Prestige and renames it “ras”. Type “quit” to exit the ftp prompt.

331 Enter PASS command Password:

230 Logged in ftp> bin

200 Type I OK

ftp> put prestige.bin ras 200 Port command okay

150 Opening data connection for STOR ras

226 File received OK

ftp: 327680 bytes sent in 1.10Seconds 297.89Kbytes/sec. ftp> quit

Figure 15-11 FTP Session Example

Note: The system reboots after a successful upload.

The following table describes some of the fields that you may see in third party FTP clients:

Table 15-2 Third Party FTP Clients - General Commands

Host Address	Enter the address of the host server.
Login Type	•	Anonymous.
	This is when a user I.D. and password is automatically supplied to the
	server for anonymous access. Anonymous logins will work only if your
	ISP or service administrator has enabled this option.
	•	Normal.
	The server requires a unique User ID and Password to login.
Transfer Type	Transfer files in either ASCII (plain text format) or in binary mode.
Initial Remote Directory	Specify the default remote directory (path).
Initial Local Directory	Specify the default local directory (path).

Configuration & Firmware Maintenance 15-7