Prestige 645 ADSL Internet Access Router

 

 

 

 

FIELD

DESCRIPTION

 

addr start / end

Source IP address range from start to end.

 

 

 

 

port start / end

Source port number range from start to end; applicable only for TCP/UDP.

 

 

 

 

Destination:

 

 

 

 

 

addr start / end

Destination IP address range from start to end.

 

 

 

 

port start / end

Destination port number range from start to end; applicable only for TCP/UDP.

 

 

 

 

Action

Specifies whether action should be taken on criteria Matched or Not

 

 

Matched.

 

Gateway addr

Defines the outgoing gateway address. The gateway must be on the same

 

 

subnet as the P645R if it is on the LAN, otherwise, the gateway must be the IP

 

 

address of a remote node. The default gateway is specified as 0.0.0.0.

 

 

 

 

Type of Service

Set the new TOS value of the outgoing packet. Prioritize incoming network

 

 

traffic by choosing No Change, Normal, Min Delay, Max Thruput, Max

 

 

Reliable or Min Cost.

 

Precedence

Set the new outgoing packet precedence value. Values are 0 to 7 or No

 

 

Change.

 

Log

Press [SPACE BAR] to select Yes to make an entry in the system log when a

 

 

policy is executed.

 

When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC]

 

to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

 

 

 

12.5 Applying an IP Policy

This section shows you where to apply the IP policies after you design them.

12.5.1 Ethernet IP Policies

From Menu 3 – Ethernet Setup, type 2 to go to Menu 3.2 – TCP/IP and DHCP Ethernet Setup.

You can choose up to four IP policy sets (from 12) by typing their numbers separated by commas, e.g., 2, 4, 7, 9.

IP Policy Routing

12-5