Prestige 645 ADSL Internet Access Router

Prestige

Wall Jack

Y -CONNECTOR

Microfilter

Wall Phone

Side Side

Figure 2-4 Connecting the Microfilter

2.6Turning On Your Prestige

At this point, you should have connected the ADSL line, the Ethernet port and the power port to the appropriate devices or lines. You can now turn on the Prestige by pushing the power button on. Refer to the Read Me First for instructions on setting up your computer. The following procedure details how to telnet into your Prestige.

Step 1. In Windows, click Start (usually in the bottom left corner), Run and then type “telnet 192.168.1.1” (the default IP address) and click OK. The Prestige should already be on when you turn on your computer, see the Read Me First for details.

Step 2. Entering the password

The login screen appears prompting you to enter the password, as shown below.

For your first login, enter the default password 1234. As you type the password, the screen displays an (X) for each character you type.

Please note that if there is no activity for longer than 5 minutes after you log in, your Prestige will automatically log you out and will display a blank screen. If you see a blank screen, press [ENTER] to bring up the login screen again.

Enter Password : XXXX

Figure 2-5 Login Screen

Hardware Installation & Setup

2-5