Chapter 5 EP Management

5.5.6 The Status Screen

Use this screen to see the status of the termination system’s interfaces. Click EP Management > Ether > Config > Status on the local termination system device to show the following screen.

Figure 18 EP Management > Ether > Config > Status (termination system)

The following table describes the items in this screen.

Table 17 EP Management > Ether > Config > Status (termination system)

LABEL

DESCRIPTION

Status

 

 

 

Link

This shows whether the port is up or down.

 

 

Speed/Duplex

This shows the speed and the duplex mode of the Ethernet connection on this port.

 

 

Flow Control

This shows whether flow control is enabled on this port.

 

 

Statistics

 

 

 

CLEAR

Click this to clear the port traffic statistics.

 

 

RxPkt

This shows how many packets have been received by this port.

 

 

RxByte

This shows how many bytes have been received by this port.

 

 

TxPkt

This shows how many packets have been sent from this port.

 

 

TxByte

This shows how many bytes have been sent from this port.

 

 

Collision

This shows how many Ethernet collisions have been detected on this port.

 

 

Error

This shows how many errors have been detected on this port.

 

 

Refresh

Click this to refresh this screen.

 

 

Back

Click Back to return to the previous screen.

 

 

5.6 Testing from the Termination System

Follow these steps to measure the noise spectrum at the termination system’s coax interface.

1Click EP Management > Test in the termination system region of the screen.

 

29

EOC350 Series User’s Guide