Chapter 5 EP Management
The following table describes the items in this screen.
Table 9 EP Management
LABEL | DESCRIPTION |
Master | This shows the version of the termination system’s EoC driver in the upload area of the |
| termination system. |
|
|
EP | This shows the version of the termination adapter’s EoC driver in the upload area of the |
| termination system. |
|
|
This shows the number of termination adapters that are online. | |
|
|
This shows the number of termination adapters that are offline. | |
|
|
Refresh | Click this to refresh this screen. |
|
|
View Host | Click this to show which hosts are connected to termination adapters. |
|
|
Igmp Group | Click this to view IGMP groups and their host members. |
|
|
No | This shows the index of the row. |
|
|
Sel | This shows which termination adapters are selected for manual upgrade or reconfiguration. |
| Click Sel to select all termination adapters. |
|
|
Link | This shows which the current link status of each device. |
| • Green: The device is online. The termination system device is always online unless its |
| EoC driver is broken. |
| • Yellow: The termination adapter is being initialized by the termination system. |
| • Red: The termination adapter is active but can’t be configured by termination system. |
| • Gray: The termination adapter is offline. |
|
|
PE (Up/Dn) | This shows the Payload Encoding (PE) in Mbps for the upstream and downstream directions |
| between each termination adapter and the termination system. Click this to refresh the |
| column. |
|
|
MAC | This shows the MAC address used over Coax. |
|
|
Model | This shows the current queried model number. |
|
|
EoC Driver | This shows the current queried working (running) EoC driver version. |
|
|
Note | This shows a user definable note for the device. |
|
|
Ether | Click Config to configure EoC and Ethernet properties of a device. These properties are |
| stored in the termination system’s nonvolatile memory and downloaded to termination |
| adapters when they power up. |
|
|
Test | Click Test to run the |
|
|
Mtn | Click Backup or Restore to download or upload a termination adapter’s configuration file. |
|
|
Upgrade EoC | Click this to upgrade the EoC drivers of the selected termination adapters with new driver in |
Driver | the termination system’s upload area. |
|
|
ReConfig | Click this to reload the EoC configuration of the selected termination adapters from the |
| termination system. |
|
|
Add EP | Click this to add an offline termination adapter profile. This is useful for provisioning |
| termination adapters before they go online. |
|
|
Del EP | Click this to add an offline termination adapter profile. This saves memory on the |
| termination system. |
|
|
5.3 The View Host Screen
Use this screen to view which hosts are connected to termination adapters. Click EP Management > View Host to show the following screen.
| 23 |
EOC350 Series User’s Guide | |
|
|