ZyXEL Communications EOC350 manual 66

Chapter 11 Telnet

Table 50 Generic Telnet Commands (continued)

COMMANDS	ARGUMENTS	DESCRIPTION
	[ ] IS OPTIONAL
snmptrapserver	[-s <set> [-c <act/deact>] [-p	Display or setup SNMP trap server(s).
	<port>] [-a <ip or host>] [-m	• <set>: trap server index, at most 5 servers
	<community>] ]
		(0~4)
		• <act/deact>: activate or deactivate trap server
		IP <ip>
		• <port>: SNMP trap UDP port number
		(0~65535), default 162
		• <ip>: trap server IP address or host name
		• <community>: trap server community name,
		default 'public'
snr	-m <mac>]	Start Online Diag over the termination adapter
	-e <mac>]	connection. This will not affect termination adapter
		(host) service.
	[-n <samples>]	• -m: termination system EoC MAC address
	[-p <period>]	• -e: termination adapter EoC MAC address
		• -n: number of samples (default 1 sample)
		• -p: period between two samples (default 10
		seconds)
sntp	[-c <act/deact>]	Display or setup SNTP.
	[-r <refresh time>]	• <act/deact>: activate or deactivate SNTP
	[-z <time zone>]	service for system time
		• <refresh time>: query SNTP server period,
	[-s <set> -a address]	default 60 minutes
		• <time zone>: '+hh:mm' or '-hh:mm' to GMT
		time, hh for hours and mm for minutes, default
		'+00:00'
		• <set>: registered SNTP server (0~1)
		• address: SNTP server host name or IP address
		in current set
stat	[-r]	Display termination system port statistics for port
		LAN1/LAN2/EoC.
		• -r: reset all port statistics counters to 0
swconfig	[-p <lan1/lan2>	Display or setup Ethernet port LAN1/LAN2
	[-s <auto /10h /10f /100h /100f>] ]	properties <lan1/lan2>: configure LAN1 or LAN2
		port
		• <auto>: auto-negotiation mode
		• <10h/10f/100h/100f>: 10/100Mbps, half/full-
		duplex mode
swigmp	[-c <on/off>]	Display or setup IGMP v2 snooping on the
		termination system
		• <on/off>: enable or disable built-in IGMP v2
		snooping function, default is off

66
	EOC350 Series User’s Guide