Chapter 5 EP Management
Figure 30 EP Management > Ether > Config > IGMP (termination adapter)
The following table describes the items in this screen.
Table 27 EP Management > Ether > Config > IGMP (termination adapter)
LABEL | DESCRIPTION |
IGMP Snooping | Select Enable to enable IGMP v1/2 fast leave. Select Disable if only IGMP v3 is |
| implemented on the network. |
|
|
Apply | Click Apply to save your settings. |
|
|
Back | Click Back to return to the main EP Management screen. |
|
|
5.8.5 The VLAN Screen
Use this screen to configure VLAN tagging on the termination adapter’s interfaces. Click EP Management > Ether > Config > VLAN on the termination adapter to show the following screen.
Figure 31 EP Management > Ether > Config > VLAN (termination adapter)
The following table describes the items in this screen.
Table 28 EP Management > Ether > Config > VLAN (termination adapter)
LABEL | DESCRIPTION |
Tag VLAN | Select Enable to enable VLAN tagging. |
|
|
Port | This shows the port name for this row. |
|
|
Priority | Select the 802.1Q priority applied to incoming frames. |
|
|
VID | Select the 802.1Q VLAN ID applied to incoming frames. |
|
|
In Rule | Select Accept All to forward all incoming frames regardless of VID. Select VID Matched to |
| forward only the incoming frames that match the port VID. |
|
|
Out Rule | Select Tag to add an 802.1Q tag to egress frames. Select Untag to remove the 802.1Q tag |
| from egress frames. Select Bypass to leave the tag of the frame alone. |
|
|
38 |
|
EOC350 Series User’s Guide | |
|
|