Chapter 5 EP Management
Figure 33 Management > Ether > Config > Status (termination adapter)
The following table describes the items in this screen.
Table 30 Management > Ether > Config > Status (termination adapter)
LABEL | DESCRIPTION |
Status |
|
|
|
Link | This shows whether the port is up or down. |
|
|
Speed/Duplex | This shows the speed and the duplex mode of the Ethernet connection on this port. |
|
|
Flow Control | This shows whether flow control is enabled on this port. |
|
|
Statistics |
|
|
|
CLEAR | Click this to clear the port traffic statistics. |
|
|
RxPkt | This shows how many packets have been received by this port. |
|
|
RxByte | This shows how many bytes have been received by this port. |
|
|
TxPkt | This shows how many packets have been sent from this port. |
|
|
TxByte | This shows how many bytes have been sent from this port. |
|
|
Collision | This shows how many Ethernet collisions have been detected on this port. |
|
|
Error | This shows how many errors have been detected on this port. |
|
|
Refresh | Click this to refresh this screen. |
|
|
Back | Click Back to return to the main EP Management screen. |
|
|
5.9 Testing from a Termination Adapter
This section describes the screens used to start diagnostic tests from a termination adapter.
5.9.1 Noise
Follow these steps to measure the noise spectrum at the termination adapter’s coax interface.
40 |
|
EOC350 Series User’s Guide | |
|
|