ZyXEL Communications EOC350 5.5.3 The QoS Screen

Chapter 5 EP Management

Figure 14 EP Management > Ether > Config > Port (termination system)

The following table describes the items in this screen.

Table 13 EP Management > Ether > Config > Port (termination system)

LABEL	DESCRIPTION
Port	This shows the port name for this row.
Speed/Duplex	Select the speed and the duplex mode of the Ethernet connection on this port. Choices are
	Auto, 10M/Full, 10M/Half, 100M/Full, 100M/Half. Selecting Auto (auto-negotiation)
	allows the port to negotiate with a peer port automatically to obtain the connection speed
	and duplex mode that both ends support. If the peer port does not support auto negotiation
	or turns off this feature, the EOC350-TS determines the connection speed by detecting the
	signal on the cable and using half duplex mode.
Flow Ctrl	A concentration of traffic on a port decreases port bandwidth and overflows buffer memory
	causing frame losses. Select On to enable flow control and regulate transmission of frames
	to match the bandwidth of the receiving port.
Enable UpRate	Select Enable to throttle the upstream bandwidth through this port.
Limit
UpRate	Type a bandwidth value in 64Kbps increments. If this exceeds 1536 (100Mbps) on an
(*64Kbps)	termination adapter LAN port or 3125 (200Mbps) on an FoC port, there will be no bandwidth
	throttling.
Enable	Select Enable to throttle the downstream bandwidth through this port.
DownRate
Limit
DownRate	Type a bandwidth value in 64Kbps increments. If this exceeds 1536 (100Mbps) on a
(*64Kbps)	termination adapter LAN port or 3125 (200Mbps) on an FoC port, there will be no bandwidth
	throttling.
Apply	Click Apply to save your settings.
Back	Click Back to return to the previous screen.

5.5.3 The QoS Screen

Use this screen to prioritize traffic flow through the termination system’s interfaces. Click EP Management > Ether > Config > QoS on the local termination system device to show the following screen.

26
	EOC350 Series User’s Guide