ZyXEL Communications EOC350 11.2.2 Generic Command Sets, 11.2.1.1 EP Default Profile

Chapter 11 Telnet

Table 49 Common Telnet Parameters (continued)

PARAMETER	DESCRIPTION
<interface>	Network interface name. E.g. 'eth0' for LAN1/LAN2 interface, 'eoc0' for EoC interface.
<fid>	The flash ROM file id represents different firmware/driver types, 'n', where n=0~12'.
	• n=0: System bootcode (termination system bootloader)
	• n=1: System firmware (termination system OS)
	• n=2: Termination system EoC driver
	• n=3: termination adapter EoC driver
	• n=10: termination adapter diagnosis utility

Only lowercase letters are accepted. Type a command followed by ENTER to execute the command.

11.2.1.1 EP Default Profile

Run EP commands with the '-m default' parameter to apply settings to theEP Default Profile. This parameter is not applicable to the 'diag', 'epreg', 'eprestore', 'epstat', 'rmep', 'showep', 'snr', and 'upep' EP commands.

11.2.2 Generic Command Sets

This table describes the generic commands available via the telnet console.

Table 50 Generic Telnet Commands

COMMANDS	ARGUMENTS	DESCRIPTION
	[ ] IS OPTIONAL
autocfg	[-t <on/off>]	Setup auto configuration by TFTP.
	[-s <ip or host>]	• -t: on (enable) / off (disable) auto
	[-p <path>]	configuration mode
		• -s: TFTP server IP address or host name
		• -p: directory path resides at TFTP server
dconfig		Dump all configurations/settings.
default		Reset all settings to factory default, including
		passwords.
dhcpsnoop		Setup DHCP snooping.
		• -m 0: disable (default)
		• 1: enable dhcp option 82
		• 2: enable dhcp option 82 and snooping
diag	-t	Run a termination adapter connection diagnostics.
	-r	This stops all service for 10~20 seconds. We
		recommend running the Online Diag command
	-m <mac>	'snr' first.
		• -t: downstream diagnosis (from termination
		system to termination adapter)
		• -r: upstream diagnosis (from termination
		adapter to termination system)
		• -m <mac>: termination adapter EoC MAC to
		be diagnosed

62
	EOC350 Series User’s Guide