ZyXEL Communications G-1000 manual Configuring WWW, Remote Management and NAT, System Timeout

G-1000 User’s Guide

8.1.2 Remote Management and NAT

When NAT is enabled:

•Use the G-1000’s WLAN IP address when configuring from the WLAN.

•Use the G-1000’s LAN IP address when configuring from the LAN.

8.1.3System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds). The G-1000 automatically logs you out if the management session remains idle for longer than this timeout period. The management session does not time out when a statistics screen is polling. You can change the timeout period in the System screen

8.2 Configuring WWW

To change your G-1000’s World Wide Web settings, click REMOTE MGMT to display the

WWWscreen.

Figure 28 Remote Management: WWW

The following table describes the labels in this screen.

Table 25 Remote Management: WWW

LABEL	DESCRIPTION
WWW
Server Port	You may change the server port number for a service, if needed; however, you
	must use the same port number in order to use this service for remote
	management.
Server Access	Select the interface(s) through which a computer may access the G-1000 using this
	service.
Secured Client IP	A secured client is a “trusted” computer that is allowed to communicate with the G-
Address	1000 using this service.
	Select All to allow any computer to access the G-1000 using this service.
	Choose Selected to just allow the computer with the IP address that you specify to
	access the G-1000 using this service.

Chapter 8 Remote Management Screens 73