ZyXEL Communications Configuring IP, by the DHCP server to access the G-1000 again, IP Setup

G-1000 User’s Guide

7.2 Configuring IP

Click ADVANCED and then IP to display the screen shown next.

Figure 27 IP Setup

The following table describes the labels in this screen.

Table 24 IP Setup

LABEL	DESCRIPTION
IP Address Assignment
Get automatically from	Select this option if your G-1000 is using a dynamically assigned IP address
DHCP	from a DHCP server each time.
	Note: You must know the IP address assigned to the G-1000
	(by the DHCP server) to access the G-1000 again.
Use fixed IP address	Select this option if your G-1000 is using a static IP address. When you select
	this option, fill in the fields below.
IP Address	Enter the IP address of your G-1000 in dotted decimal notation.
	Note: If you change the G-1000's IP address, you must use the
	new IP address if you want to access the web configurator
	again.
IP Subnet Mask	Type the subnet mask.
Gateway IP Address	Type the IP address of the gateway. The gateway is an immediate neighbor
	of your G-1000 that will forward the packet to the destination. On the LAN, the
	gateway must be a router on the same segment as your G-1000; over the
	WAN, the gateway must be the IP address of one of the remote node.
Apply	Click Apply to save your changes back to the G-1000.
Reset	Click Reset to begin configuring this screen afresh.

Chapter 7 IP Screen 71