Prestige 334W User’s Guide

 

 

Table 9-5 WAN: IP

 

 

 

 

 

LABEL

DESCRIPTION

 

 

 

 

 

 

Allow between WAN

Select this check box to forward NetBIOS packets from the LAN to the WAN and

 

 

and LAN

from the WAN to the LAN. If your firewall is enabled with the default policy set to

 

 

 

block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall

 

 

 

rule that forwards NetBIOS traffic.

 

 

 

Clear this check box to block all NetBIOS packets going from the LAN to the WAN

 

 

 

and from the WAN to the LAN.

 

 

Allow Trigger Dial

Select this option to allow NetBIOS packets to initiate calls.

 

 

 

 

 

 

Apply

Click Apply to save your changes back to the Prestige.

 

 

 

 

 

 

Reset

Click Reset to begin configuring this screen afresh.

 

 

 

 

 

9.6Configuring WAN MAC

To change your Prestige’s WAN MAC settings, click WAN, then the WAN MAC tab. The screen appears as shown.

Figure 9-6 MAC Setup

The MAC address screen allows users to configure the WAN port's MAC address by either using the factory default or cloning the MAC address from a computer on your LAN. Choose Factory Default to select the factory assigned default MAC Address.

Otherwise, click Spoof this computer's MAC address - IP Address and enter the IP address of the computer on the LAN whose MAC you are cloning. Once it is successfully configured, the address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the setting or upload a different ROM file. It is recommended that you clone the MAC address prior to hooking up the WAN Port.

WAN Screens

9-11