Prestige 334W User’s Guide
The second is that the Prestige will try to bring up the connection when turned on and whenever the connection is down. A
Do not specify a
The following table describes the fields not already described in Table
FIELD | DESCRIPTION | EXAMPLE |
|
|
|
Service Name | If you are using PPPoE encapsulation, then type the name of your | poellc |
| PPPoE service here. Only valid with PPPoE encapsulation. |
|
Authen | This field sets the authentication protocol used for outgoing calls. | CHAP/PAP |
| Options for this field are: |
|
| CHAP/PAP - Your Prestige will accept either CHAP or PAP when |
|
| requested by this remote node. |
|
| CHAP - accept CHAP only. |
|
| PAP - accept PAP only. |
|
Telco Option |
|
|
|
|
|
Allocated | The field sets a ceiling for outgoing call time for this remote node. The | 0 |
Budget | default for this field is 0 meaning no budget control. | (default) |
|
|
|
Period(hr) | This field is the time period that the budget should be reset. For | 0 |
| example, if we are allowed to call this remote node for a maximum of 10 | (default) |
| minutes every hour, then the Allocated Budget is (10 minutes) and the |
|
| Period(hr) is 1 (hour). |
|
Schedules | You can apply up to four schedule sets here. For more details please |
|
| refer to the Call Schedule Setup chapter. |
|
|
|
|
This field specifies if you want to make the connection to this remote | No | |
Connection | node a | (default) |
| section. |
|
|
|
|
Session Options |
|
|
|
|
|
Idle Timeout | Type the length of idle time (when there is no traffic from the Prestige to | 100 seconds |
| the remote node) in seconds that can elapse before the Prestige | (default) |
| automatically disconnects the PPPoE connection. This option only |
|
| applies when the Prestige initiates the call. |
|
|
|
|
Remote Node Configuration |