ZyXEL Communications unified security gateway manual 168

Chapter 8 Dashboard

Table 19 Dashboard (continued)

LABEL	DESCRIPTION
Device	This field displays the name of the device connected to the extension slot
	(or none if no device is detected).
Status	This field displays the current status of each interface or device installed
	in a slot. The possible values depend on what type of interface it is.
	For Ethernet interfaces:
	Inactive - The Ethernet interface is disabled.
	Down - The Ethernet interface does not have any physical ports
	associated with it or the Ethernet interface is enabled but not connected.
	Speed / Duplex - The Ethernet interface is enabled and connected.
	This field displays the port speed and duplex setting (Full or Half).
	(For USG 20W only) The status for an installed WLAN card is none.
	For cellular (3G) interfaces, see Section 11.5 on page 239 for the status
	that can appear.
Zone	This field displays the zone to which the interface is currently assigned.
IP Address/	This field displays the current IP address and subnet mask assigned to
Mask	the interface. If the interface is a member of an active virtual router, this
	field displays the IP address it is currently using. This is either the static
	IP address of the interface (if it is the master) or the management IP
	address (if it is a backup).
Device	This identifies a device installed in one of the ZyWALL’s extension slots
	or USB ports.
Device
Information
System	This field displays the name used to identify the ZyWALL on any
Name	network. Click the icon to open the screen where you can change it. See
	Section 43.2 on page 630.
Model	This field displays the model name of this ZyWALL.
Name
Serial	This field displays the serial number of this ZyWALL.
Number
MAC	This field displays the MAC addresses used by the ZyWALL. Each physical
Address	port has one MAC address. The first MAC address is assigned to physical
Range	port 1, the second MAC address is assigned to physical port 2, and so
	on.
Firmware	This field displays the version number and date of the firmware the
Version	ZyWALL is currently running. Click the icon to open the screen where
	you can upload firmware. See Section 45.3 on page 700.
System Status
System	This field displays how long the ZyWALL has been running since it last
Uptime	restarted or was turned on.
Current	This field displays the current date and time in the ZyWALL. The format
Date/Time	is yyyy-mm-dd hh:mm:ss.
VPN Status	Click this to look at the VPN tunnels that are currently established. See
	Section 8.2.1 on page 171.

168
	ZyWALL USG 20/20W User’s Guide