ZyXEL Communications unified security gateway manual 257

Chapter 11 Interfaces

Table 60 Configuration > Network > Interface > WLAN > Add (No Security)

LABEL	DESCRIPTION
Direction	This field is effective when RIP is enabled. Select the RIP direction
	from the drop-down list box.
	BiDir - This interface sends and receives routing information.
	In-Only- This interface receives routing information.
	Out-Only- This interface sends routing information.
Send Version	This field is effective when RIP is enabled. Select the RIP version(s)
	used for sending RIP packets. Choices are 1, 2, and 1 and 2.
Receive	This field is effective when RIP is enabled. Select the RIP version(s)
Version	used for receiving RIP packets. Choices are 1, 2, and 1 and 2.
V2-Broadcast	This field is effective when RIP is enabled. Select this to send RIP-2
	packets using subnet broadcasting; otherwise, the ZyWALL uses
	multicasting.
OSPF Setting	See Section 14.3 on page 315 for more information about OSPF.
Area	Select the area in which this interface belongs. Select None to disable
	OSPF in this interface.
Priority	Enter the priority (between 0 and 255) of this interface when the area
	is looking for a Designated Router (DR) or Backup Designated Router
	(BDR). The highest-priority interface identifies the DR, and the
	second-highest-priority interface identifies the BDR. Set the priority to
	zero if the interface can not be the DR or BDR.
Link Cost	Enter the cost (between 1 and 65,535) to route packets through this
	interface.
Passive	Select this to stop forwarding OSPF routing information from the
Interface	selected interface. As a result, this interface only receives routing
	information.
Authentication	Select an authentication method, or disable authentication. To
	exchange OSPF routing information with peer border routers, you
	must use the same authentication method that they use. Choices are:
	Same-as-Area- use the default authentication method in the area
	None - disable authentication
	Text - authenticate OSPF routing information using a plain-text
	password
	MD5 - authenticate OSPF routing information using MD5 encryption
Text	This field is available if the Authentication is Text. Type the
Authentication	password for text authentication. The key can consist of alphanumeric
Key	characters and the underscore, and it can be up to eight characters
	long.
MD5	This field is available if the Authentication is MD5. Type the ID for
Authentication	MD5 authentication. The ID can be between 1 and 255.
ID
MD5	This field is available if the Authentication is MD5. Type the
Authentication	password for MD5 authentication. The password can consist of
Key	alphanumeric characters and the underscore, and it can be up to 16
	characters long.

	257
ZyWALL USG 20/20W User’s Guide