Chapter 43 System

43.3 USB Storage

The ZyWALL can use a connected USB device to store the system log and other diagnostic information. Use this screen to turn on this feature and set a disk full warning limit.

Note: Only connect one USB device. It must allow writing (it cannot be read-only) and use the FAT16, FAT32, EXT2, or EXT3 file system. The ZyWALL uses the partition identified as “sda1”.

Click Configuration > System > USB Storage to open the screen as shown next.

Figure 368 Configuration > System > USB Storage

The following table describes the labels in this screen.

Table 191 Configuration > System > USB Storage

LABEL

DESCRIPTION

Activate USB

Select this if you want to use the connected USB device(s).

storage

 

service

 

 

 

Disk full

Set a number and select a unit (MB or %) to have the ZyWALL send a

warning when

warning message when the remaining USB storage space is less than the

remaining

value you set here.

space is less

 

than

 

 

 

Apply

Click Apply to save your changes back to the ZyWALL.

 

 

Reset

Click Reset to return the screen to its last-saved settings.

 

 

43.4 Date and Time

For effective scheduling and logging, the ZyWALL system time must be accurate. The ZyWALL’s Real Time Chip (RTC) keeps track of the time and date. There is also

 

631

ZyWALL USG 20/20W User’s Guide