Chapter 1 Introducing the ZyWALL

console port. See the Command Reference Guide for more information about the CLI.

Console Port

You can use the console port to manage the ZyWALL using CLI commands. See the Command Reference Guide for more information about the CLI.

The default settings for the console port are as follows.

Table 2 Console Port Default Settings

SETTING

VALUE

Speed

115200 bps

 

 

Data Bits

8

 

 

Parity

None

 

 

Stop Bit

1

 

 

Flow Control

Off

 

 

1.5 Starting and Stopping the ZyWALL

Here are some of the ways to start and stop the ZyWALL.

Always use Maintenance > Shutdown > Shutdown or the shutdown command before you turn off the ZyWALL or remove the power. Not doing so can cause the firmware to become corrupt.

Table 3 Starting and Stopping the ZyWALL

METHOD

DESCRIPTION

Turning on the

A cold start occurs when you turn on the power to the ZyWALL. The

power

ZyWALL powers up, checks the hardware, and starts the system

 

processes.

 

 

Rebooting the

A warm start (without powering down and powering up again)

ZyWALL

occurs when you use the Reboot button in the Reboot screen or

 

when you use the reboot command. The ZyWALL writes all cached

 

data to the local storage, stops the system processes, and then does

 

a warm start.

 

 

Using the RESET

If you press the RESET button, the ZyWALL sets the configuration

button

to its default values and then reboots.

 

 

34

 

ZyWALL USG 20/20W User’s Guide