Chapter 12 Maintenance
Table 49 | Maintenance > Backup/Restore | |
LABEL |
| DESCRIPTION |
Upload |
| Click Upload to begin the upload process. |
|
| Note: Do not turn off the WAP3205 v2 while configuration file upload is in progress. |
|
| After you see a “configuration upload successful” screen, you must then wait one minute |
|
| before logging into the WAP3205 v2 again. The WAP3205 v2 automatically restarts in this |
|
| time causing a temporary network disconnect. |
|
| If you see an error screen, click Back to return to the Backup/Restore screen. |
|
|
|
Reset |
| Pressing the Reset button in this section clears all |
|
| and returns the WAP3205 v2 to its factory defaults. |
|
| You can also press the RESET button on the rear panel to reset the factory defaults of your |
|
| WAP3205 v2. Refer to the chapter about introducing the Web Configurator for more |
|
| information on the RESET button. |
|
|
|
Note: If you uploaded the default configuration file you may need to change the IP address of your computer to be in the same subnet as that of the default WAP3205 v2 IP address (192.168.1.2). See Appendix C on page 139 for details on how to set up your computer’s IP address.
12.8 Reset/Restart Screen
System restart allows you to reboot the WAP3205 v2 without turning the power off. Click Maintenance > Reset/Restart to open the following screen.
Figure 78 Maintenance > Reset/Restart
Click Restart to have the WAP3205 v2 reboot. This does not affect the WAP3205 v2's configuration.
| 111 |
WAP3205 v2 User’s Guide | |
|
|