ZyXEL Communications WAP3205 Access Point Mode

3

Access Point Mode

3.1 Overview

The WAP3205 v2 is set to access point mode by default. In this mode your WAP3205 v2 bridges a wired network (LAN) and wireless LAN (WLAN) in the same subnet. See the figure below for an example.

Figure 6 Wireless Internet Access in Access Point Mode

Note: See Chapter 8 on page 59 for an example of setting up a wireless network in Access Point mode.

3.2What You Can Do

•Use the Status screen (Section 3.4 on page 18) to view read-only information about your WAP3205 v2.

•Use the LAN screen (Chapter 11 on page 101) to set the IP address for your WAP3205 v2 acting as an access point.

•Use the Wireless LAN screens (Chapter 10 on page 83) to configure the wireless settings and wireless security between the wireless clients and the WAP3205 v2.

	17
WAP3205 v2 User’s Guide